A faucet that suddenly sprays sideways, sputters, or slows to a weak stream may have nothing wrong with its valve at all. The small screen at the tip of the spout, the aerator, can collect mineral scale and debris, and it's one of the easiest parts to check before you assume a bigger repair. It isn't the only possible cause, though, so it helps to know what a cleaning can and can't tell you.
What the Aerator Does
The aerator is the small cap screwed onto the end of most kitchen and bathroom faucets. Inside it, one or more fine screens break the water into a smooth, even stream and mix in a little air, which reduces splashing.
Because every drop of water passes through those screens, anything carried in the water — bits of scale, sediment after plumbing work, or small debris from old pipes — can lodge there. Over time, a partial blockage can change the spray pattern or reduce flow.
Signs Worth Checking First
A clogged aerator tends to show up as a stream that splits, sprays at an angle, or comes out weaker than it used to, especially if the change happened at only one faucet. If both hot and cold are affected equally at that faucet while other faucets in the house run normally, the aerator is a reasonable first suspect.
If every faucet in the house loses pressure at once, the cause is more likely upstream — a supply issue, a partially closed valve, or a problem with the home's water service — and cleaning one aerator won't change it.
Removing and Cleaning It
Close the drain or set a towel in the sink first, since the aerator's small parts are easy to lose. Most aerators unscrew by hand, turning counterclockwise when viewed from below. If one is stuck, wrap it in a cloth before gripping it with pliers so the finish isn't scratched; some recessed aerators need a small key that comes with the faucet or is sold separately.
Note the order of the washer, screens, and housing as they come apart. Rinse the pieces, brush them gently with an old toothbrush, and, if mineral scale remains, soak them in white vinegar for a while before rinsing again. Reassemble in the same order and thread the aerator back on by hand until snug.
When Cleaning Doesn't Fix It
If the flow is still weak or uneven after a cleaning, the aerator may be worn or damaged, and replacing it is inexpensive. Bring the old one with you or check its thread and size against the replacement's listing, because aerators come in different sizes and in male or female threads.
If a new aerator doesn't help either, the problem may sit further inside the faucet, such as in the cartridge or valve. Matching a Replacement Faucet Part to Your Valve Type, Not Just the Faucet Brand explains how to identify those parts.
Common Questions
Q: Do I need to shut off the water to clean an aerator?
Usually not, since the aerator sits on the outlet side of the valve. Just make sure the faucet is fully off before you unscrew it.
Q: Can I run the faucet without the aerator while it soaks?
Typically yes for a short time, though the stream will splash more. Reinstall it before regular use so the water flows evenly.
Checking Parts and Replacements
When a cleaning isn't enough, the Faucet Parts collection lets you compare replacement parts; check each listing's stated thread type and size against the part you removed.
- Compare the problem faucet with others in the house to narrow the cause
- Cover the drain before unscrewing the aerator
- Note the order of washers and screens as they come apart
- Clean with a soft brush and, if needed, a vinegar soak
- Match thread type and size before buying a replacement
A sputtering faucet is often a five-minute fix at the spout. If cleaning and replacing the aerator don't restore a smooth stream, that result itself is useful: it points you toward the cartridge or the supply instead.